It's not uncommon for the tiny microswitch thing inside the headphone jack socket to get stuck. I have only now realised the what you have described is your iMac maybe stuck on "Digital Out" which usually results from having headphones connected. Audio from the Stomp should now be directed to the speakers onboard the iMac, unless I have misunderstood the question? To achieve what you’re after, select the Output tab at the top of the System Sound panel (within the System Prefs panel) and from that window chose “Internal Speakers - built in”. As you state you can see an audio input signal in the System Sound input settings (within the System Prefs panel) then your chosen input option must be already set to HX Stomp. My Helix is permanently tethered to my studio Mac for recording and monitoring through my Tannoy Reveals, but I can still use the speakers in the iMac if I want. I’m not in the studio right now, but I think this should be easy enough. If I select HX Stomp as output, I hear it through the HX Stomp's headphone output, as indicated in the manual. Does the HX Stomp only output to itself, or is there a way to get it to play through the mac for practicing without going through a DAW? I've installed the Helix Driver 1.0.5 thinking that would make this possible, but no dice. Is there a way to hear the HX Stomp directly through my mac's speakers when connected via USB?Ĭonnecting an HX Stomp to an iMac running OS 10.13.6 High Sierra via USB shows an audio input level in the system Sound input settings window but I'm not getting audio through the selected output: Digital Output. Nothing about the computer's audio output. It says Computer Output / Destinations are: USB 1/2> HX Stomp Main L/R USB 3/4>HX Stomp stereo SEND USB 5/6> HX Stomp Input block. Under USB Audio, the manual only talks about connecting output through either the HX Stomp or through a DAW. And check out the USB Audio section in the Stomp manual to make sure your USB audio is set up correctly." "Take a look in the Audio Devices window, and you can assign stuff in the left panel. ![]() I've done this, and yes, both input and output are assigned: input=HX Stomp, Output=Built In Output in the Audio Devices window (as 24-bit 48k) (This does not change the iMac's digital output from its default 44.1k to 48k)Ģ. "Take a look at Audi MIDI Setup (Mac application) and see if you can assign your input and output there." Do you know for a fact this can be done? Have you done this?ġ. ![]() And check out the USB Audio section in the Stomp manual to make sure your USB audio is set up correctly. Take a look in the Audio Devices window, and you can assign stuff in the left panel. Take a look at Audi MIDI Setup (Mac application) and see if you can assign your input and output there.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |